XYZ Printing Da Vinci Jr. Pro - Raspberry Pi Zero W Mount

I'm using the original ZeroW Raspberry case with octoprint installed to check on my prints. I was looking for a place to mount the raspberry and noticed the spoolholder for the small xyz spools inside the printer. I use my own spool holder and route the filament from the backside into the printer, so this space was available.

I used a premade mount for the zeroW (can't find the source anymore) and modelled a base around it which fits perfectly in the internal spool holder. You can even close the door with the power cable attached to the pi, there is enough room between the door and the frame.

I attached a view from the inside of the printer, just print the stl file and put it in place. If you want to change the angle or design your own mount you can use the scad and additional stl file.

The mount can also be used as a stand next to any printer, see attached screenshot of my custom made 3Dtje mini prusa style printer. https://www.thingiverse.com/make:459694

Print instructions

Print Settings

Printer: XYZ Printing Da Vinci Jr. Pro

Rafts: No

Supports: Yes

Resolution: 0.2mm

Infill: 15%

Filament: DAS FILAMENT PLA Black