Greedy Cup w/o Center Column

This model has a smaller channel than most other models, which provides a slower drip or stream. I have been able to drain the cup in it's entirety as long as the water is able to enter the hole. The smaller channel provides a better siphon than those which are larger. This cup could be used as a pen/pencil holder as well.

Printed on a Monoprice Mini Delta v1

Filament: PLA

Nozzle temp: 190c

Bed temp: 40c

Layer Height: 0.14

Walls: 3

Support: Manually added under lower and upper handle. Could use tree's, I didn't. Do not print “everywhere” and be careful where you place supports because they can block the channels. Don't let them overlap the model much.

Adhesion: none