Holder for Xiaomi Temperature and Humidity Monitor 2 remix

The original design was built like a tank, so I needed a weakened version ;)
3
24
0
245
updated December 1, 2024

Description

PDF

I needed a pla friendly weakened version of the original design without any screws. 

 

This design is too close to the ender 3 v2's screen if you use it on the right side, but I have no problems since I use it towards the front of the printer as seen in the photos.

The slots between the leg and case part is tight and small, but it will work fine if you pay attention cleaning the tiny overhangs if there are any.

No supports needed and if you need support then its time to upgrade your printer.. :)

 

cheers!

 

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

licence

License