Scout 32 - Custom Snap in USB Holder

Scout 32 - Custom Snap in USB Holder with built in zip-tie management.   Can be used to hold anything else as well.

This Model I originally found on the website: Scout32 – ESP32 WiFi FPV Camera Rover – Pilot Hobbies

Then found same one here: Scout32 ESP32 WiFi FPV Camera Rover by Ross Peters | Download free STL model | Printables.com

Built the model, but wanted cheap and commonly available way to power it up.

The diameter of the holder is ~34mm.  My USB Battery pack was just about 32mm in diameter.

Print Settings in Prusa Slicer

• 0.4mm nozzle
• 0.2mm layer height
• 15% infill
• Printed in Overture PLA
• Basically default settings

INSTALLATION NOTES:

• This is a tight fit.
• Read this again, this model was designed to be a very tight fit and will take a considerable of force to snap it into place.
• Worked perfectly for my need.