IKEA HOVSTA iPad Air Photo Frame

Included Files

STL and 3MF files for the whole frame are included for larger printers with a printable area of at least 220x310mm, as well as a two-part split print for smaller print beds down to 220x160mm.

Supports are recommended if your printer doesn't like 45º overhangs.

Post-Processing

If your print has a gap between the two halves, use an appropriate adhesive or filler between the two halves, test-fit to your iPad, and remove the iPad before the adhesive/filler fully cures.

A light sand and/or a top-coat of etch-primer may help to smooth any artefacts present, particularly on bevelled edges, or to cover any filler used between the two halves.

Design Notes

Created from device dimensions specified in the Apple Accessory Design Guidelines, available here https://developer.apple.com/accessories/Accessory-Design-Guidelines.pdf

This mount preserves ambient light sensor function, and access to the Home button on the front-face.

No provisions are made for access to the Power and Volume buttons from the front; but finger-holes are provided to access these functions from the rear.

Legal Notice

Commercial use of products containing Apple Word-Marks or the Keyboard Apple Logo is forbidden by Apple IP Guidelines, as it contains embossed elements generated from the Keyboard Apple Logo. https://www.apple.com/legal/intellectual-property/guidelinesfor3rdparties.html 

Reprinting for personal non-commercial use only of the files located in the included “3MF Non-Commercial Only” or “STL Non-Commercial Only” is permissible under the above definition.

For any commercial use including manufacture or reselling, you must use the files located in the included “3MF Commercial Use Accepted” or “STL Commercial Use Accepted” folders.

You are solely responsible for ensuring your compliance with Apple Intellectual Property Guidelines.