Ender 3 S1/S1Pro Isolation Feet Mounts

I created these mounts to fit the Hudson Hi-Fi 1.5” Bigfoot Isolation Feet as I found that when using the squash balls, the squash balls would get squashed too much and most of the weight was at back which created a slight tilt backwards of the entire printer.

I find these are a lot more sturdy despite being much larger.

I created this using a 2 part Design for ease of printing.

1. 1 full set (top & bottom models together) requires the below per set:
   Combining both top and bottom:
   • 3x M3 (Flat Head) Screws 12mm 
   • 3x M3 Hex Nuts
2. Mounting to Printer frame:
   • 1xM5 Hex Screw 18mm (16mm will work)
   • 1xM5 T-Nut

3D PRINTING SETTINGS

Material: PLA
Infill: 20%-25%
Perimeters: 3 (min recommendation)
Layer Height: 0.2mm (0.24mm for First Layer)

Speed : Print at the speed and acceleration you prefer (I printed at 65mm/s default. 25mm/s First layer and small perimeters)