Sprite/ender 3 s1 extruder flat cable holder for CR10 V3

This holder is used for holding the flat cable of a Sprite extruder (Ender3 S1 extruder) on a CR10 V3 extruder metalic plate. 

If you are using a different 3D printer with a different extruder, then open up the f3d file in fuson360 and check the sizes, then do the changes you need. Please don't forget to mark it as a mix to my model.

This holder should allow you to easily remove the cable out of it if you need to take the electronic unit away.

I am still learning fusion360. The first version was fine, but I had big tolerances. I didn't bother printing a second one for me, but I made the model again and decreased the tolerances.

I also added the f3d file in case you need to modify it for your printer.

If you found it useful, then please don't forget to post some photos!