IKEA Trådfri switch holder for Skådis

This Trådfri switch holder for Skådis that uses the T-Nuts for Ikea Skadis Pegboards system from 6d6178. The switch is attached to the holder by a 6mm magnet, so that the metal base plate isn't needed.

Details to be mentioned

• The holders is mounted to the Skådis board with one T-nut (using a M2.5x12 screw).
• The magnet (6x2mm) press fits into the holder
• The magnet can be removed with a small screw driver
• When printed
  • The holder should be printed with the backside to the print bed
  • Activate support for the cavity that holds the alignment guide
  • The alignment guide can be glued into the cavity if you like