This is a tray holder in the form of steps with bicycle railings. It has a cool and fashionable look suitable for table top use. It consists of two coasters that can be used for drinks, and can hold small parts for just about any small thing(s). I use it to hold my bicycle lights.
Printing is simple. I use 0.2mm layers with PETG filament. For best aesthetics/look, I suggest printing components separately using different colored filament and then assembling the rails which slot into the side of the steps with a bit of gentle nudging.
Note that the outer shell ("tray coaster steps) prints fine in the position shown here without using supports. There will be some stringing on the fist layers of the bottom of the top shell, but these do not interfere with drawer function.
Enjoy!
The author marked this model as their own original creation.