Ergonomic Oblique Calligraphy Pen Nib Holder

To build this nib holder, please follow below guide:

Parts or tools required:

• Oblique flange (Dip pen flange)

Go search in Ebay or AliExpress.

• 2mm Drill Bit (Optional)
• Hacksaw with nearly 1mm thick blade (Optional)

Build steps:

1. Print the nib holder and get the parts. Please prevent to put supports in the slot.
2. Push flange into the slot of nib holder.
3. (Optional) You may need to use the 2mm Drill Bit to make the center hole larger and remove support/waste in the center hole
4. (Optional) You may need to use the hacksaw to saw a little bit if there any support/waste in the slot.
5. After push flange into the slot of nib holder, you can put your favorite nib and start writing!

Feel free to remix and thanks for making this.

Print Settings

Printer:

DIY 3D Printer

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.1

Infill:

25%

Notes:

25% infill is good balance for me about the weight.
Please prevent to put supports in the slot otherwise you may need to drill and saw the slot.