Just a basic sign I wanted for my wall. I couldn't find any that fit the bill quite like I wanted, so I made my own. Each of the major piece's end at different layer heights so if you dont have an MMU/AMS system you can colorize it by filament swap @ layer heights.
I made a small one ~280mm wide, and a giant one almost 600mm wide (cutting it in half).
PLA works fine
0.20 layer height (or thicker) is fine.
no supports needed. Size and/or section for whatever size you want.
If you do print it smaller than 300mm, ensure you turn on thin wall detection or it may not put the line in the middle of the letters.
The author marked this model as their own original creation.