Cheshire Cat - MMU

MMU version of the Cheshire Cat from Alice and Wonderland

In order to make this model mostly support free, this is a two piece model (head, body) that require gluing together. It should be noted that the head by itself sits well and does not require the body.

This MMU model was derived from my non-MMU model:

https://www.prusaprinters.org/prints/411-cheshire-cat

Enjoy, and don't forget to post your makes!

Print instructions

There are two 3MF files attached. One for just the head and one for the body. The head is just over a four hour print and can be used by itself.

I've also included all the STL files in case you decide to print both the head and body at the same time.

All the supplied files are for the smallest recommended size of the model. The model can be sized up without issue, but I would not recommend sizing it down any further.