E3D v6 (new version, cartridge thermistor) Silicone Cover

This is a replacement silicone cover for the original E3D V6 (new version).
The original cover does not stay in place.

Just print all 3 parts, connect them and mold your cover.

Instructions:
Print everything with about 20%-25% infill. You should print the parts with 0.1mm layer height for a smoother finish.

To fill the silicone into the mold I use these needles and a normal syringe
http://bit.ly/3Fx9dtq

Wait about 2 hours till the silicone is dry to clean everything.

BOM:
4x M2 x 8mm screw
4x M3 x 8mm screw

1x 6mm metal pipe

1x silicone (shore 33 up to 450 degree Celsius)
https://goo.gl/yVxw4y