Quest 2 Kiwi Anker PowerCore 13000 Battery Holder

This is a battery mount for a Quest 2 HMD with the Kiwi headstrap. It attaches a Anker PowerCore 13000 to the rear of the headstrap to balance the headset out, and increase the battery life substantially.

This mount is attached via two cable ties through the rear bottom loop. You will need to remove the bottom pad, cable tie the mount tightly, then reapply the velcro pad which will keep the mount from moving left/right. For additional security, I recommend using a velcro cable tie on the top to secure the battery. It can be used without a velcro strap, but under certain extreme situations the battery could lift out. The velcro tie also keeps it completely solid with no rattles.

Supplies needed:

• Quest 2 headset

• Kiwi headstrap

• Anker PowerCore 13000

• (2) cable ties

• (1) velcro cable tie (12.5mm x ~75mm)

The preferred print orientation is vertically, as modeled, and a slide/support recommendation is shown above in the images.