I designed this model to hold the remotes for my stereo system.
It is designed to be printed in 2 pieces and glued together.
If done correctly it doesn't need any supports… a Brim is helpful to keep the bottom part from warping.
The tab at the top was designed with a recessed section for attaching it to the edge of my stereo cabinet with double faced foam tape. I considered doing this with a simple hole for a screw, but I didn't want to screw into the stereo cabinet.
The top and bottom pieces were glued together with a bit of superglue.
I printed it in Black Hatchbox PLA on an Elegoo Neptune 2.
I considered making the letters as separate pieces that could be printed out in a contrasting color… I may still do this. If I do I'll update the model.
The author marked this model as their own original creation.