This is an enhanced version of my extended design, with threads for two bowden tube fittings, this allows you to have a tube from the dryer to the arm, and from the arm to the printer, perfect for filaments like nylon that can absorb enough water in one hour to require drying again.
Print upright, no supports required. If the threads are less than ideal after printing, simply heat the pocket with a jet torch or similar and then screw the fitting into the softened filament.
3 walls
15-20% 3d infill
No support or brim needed
Printer:
Tronxy XY2-Pro
Rafts:
No
Supports:
No
Resolution:
0.20 layers
Infill:
15% 3D fill
Filament:
3dmax pla+white
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.