Print two 20x120 columns, then place them under the x-axis resting on the legs of the printer so you can release all of the fasteners on the x-axis and make it flat again.
Some printers do not have keyed bracket bolt points for the x-axis, and a loose bolt can make the x-axis crooked.
If your axis is crooked, you will need to print this on a working printer, preferably one with with good accuracy.
Printer Brand:
FlashForge
Printer:
Guider II
Rafts:
No
Supports:
No
Resolution:
0.4mm
Infill:
15% gyroid
Filament: llldmax pla+ white
Notes:
Print it slow and with little bed heat so there is no elephant's foot.
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.