Niimbot Label Roll Holder

Just a small rack to store your Niimbot labels.

I designed it for new rolls to have a tight fit, but there are no separators since I have 2 different sizes of labels.
This means that used labels will move around freely, I just squeeze them between the wall and a full roll.

Also added a small cut on the left side to store the white plastic part that has to be placed in the D101 when printing the narrower labels. This is not a tight fit, because the plastic part is not formed very convenient, but it gets the job done
 

Prints without support with the bottom side of the model on the build-plate
Printed in Extrudr PLA NX2 Epic Purple
→ Will fit on a Prusa Mini when turned 45°, see third picture