VZ-Hextrudort For Stealthburner (door and tension screw fix)

Attention! the description will be updated soon (see updates as changelog)

This remix replaces the printet standoffs with standoffs female to female 25mm (like this and this together or similar m3x25) because they are narrower in diameter.

Only the material that was absolutely necessary was removed from the cable door. Now the transition to the rear door is flush again.

The left screw on the PCB mount (SHT36) has been countersunk and the arm made thinner to further save space.

Like the original, no supports needet except for the Cable Door and the EBB36 mount!

I use this mod to get better at Fusion 360 and would also like to incorporate suggestions for improvement into my learning curve. Suggestions are always welcome.

update 05.02.2023:
The transition at the entrance of the Bowden tube is now smooth and even. Also, the upper hole is now closed. Now it should be in a stable version.

update 29.01.2023:
The front body has a connection at the tension screw and a round hole. It's more stable now.

update 28.01.2023: 
Now there is a mount for the EBB36. Unfortunately, I don't have one lying around and therefore had to make the adjustment blindly without testing it. As with the SHT36, the left arm has become thinner. Both screw holes for the extruder mount were also slightly countersunk. 
I was surprised why the holes for the attachment to the standoffs have such a large diameter in the original. This was adapted now for m3 screws.