HEX Remix mod of 3DO Nozzle camera mount for Voron Stealthburner

i am at a lose here . how do your prints come out with the hex pattern. mine don't even print the hexes and i can pause to change the filament.

This printed out great with filament swap on my old prusa clone. and has been working well for a few hundred hours of printing. Thank you! (edited)

Thank you for the design, pleased with how it came out even though this is likely just a temporary print until I get my Voron bootstrapped. Now to fit everything in!

What is the board that your fans are plugging into? I see the 3do camera board, but what is that second board? do i need that to make this work?.. I didnt get that with my camera package... So hopefully thats optional??

Done ✅

How did you route the USB cable from the camera board? I installed mine in the same location but flipped 180 so USB is at the top. I cut a slot for the cable to exit there and don't run it in the cable chain. Follows the filament to the top of the printer. It is quite a challenge to route the rigid-flex cable without breaking it. Held my breath the whole way.

Hello
Thanks for the model which one should I print for Revo E3D (edited)

Just Perfect, Thanks

Very pretty model. One small issue: The camera housing is too low, could collide with print also touches the bed before the nozzle tap probe does. I just cut off maybe few milimeters with pliers

My first multi-colored print and besides it not starting perfectly aligned it turned out great!