Durham Mfg Parts Tray

3, 4 and 12 compartment parts tray for the large Durham Manufacturing (MFG) steel drawer cabinets. Not for small Durham cabinets. 

Print 8 times to fill one drawer. 

I've included the model files if you would like to remix or adjust parameters. 

*NOTES*

Because this is a wide and shallow print, be sure to use gluestick on the print bed. Without glue, there is a high risk of the corners warping. 

Will take 7-9 hours to print at standard speed. I print at .30mm height and increase the print speed to 130%. If using a Prusa Printer, I like to enable fuzzy skin for the outside perimeter walls. 

Modeled to be a loose fit, so that there is no interference between each tray or the drawer. Stacked two trays high, there will still be clearance for the lid to close.