Skateboard/Longboard wall hanger

This is a Skateboard/Longboard hanger that doesn't require any support, it should be able to hold any size board. it takes about 6 hours to print per piece, so 12 hours total print time. u will also need 4 screws to secure this thing to a wall regular screws that are longer than 1 ½' should work fine. it also doesn't matter if u screw in the screws by hand or with a power tool both should do just fine.

Recommended settings 
30%-100% infill
layer height doesn't matter 
4 or more walls                                                                                                                                     abs or petg

The print settings I used
30% infill cubic 
layer height .2
4 walls 
petg