Ender 5 plus corexy converted microswiss orbiter carriage.

This is a remix of a carriage for coreXY conversion of ender 5 plus. See the remix section for more info on conversion.

needed components:

• 8 short heat insets M3x3.
• Orbiter v1.5
• 5015 and 4010 fans.
• two long countersunk m3 screws (around m3x25 or m3x30) for hotend mount.
• six button head m3x15 screws. (two for orbiter, two for 4010 fan, two for bltouch and print fan segments).

At the back there are 2 additional vertical heat insets to be used as desired, I planned to add ADXL sensor

To be printed with ABS at least. 

Microswiss mount block should be printed with the most heat resistant material possible.

If you want something modified I can upload a .step file but it is a mess.

things that needs to be addressed:

•  belt is making a little bit to much tension on the bl-touch causing bed mesh to be incorrect in front right corner.
• overall fan duct performance