Low Poly Unicorn

I remixed the Low-Poly Unicorn by chopping part of the base off and adding some extra to the back so the unicorn head could stand upright on top of a trophy base.

I used rainbow filament which made for a really cool look, but the supports messed up on the chin area.

Printed at 0.2mm layer height with a 0.6mm nozzle. Supports are necessary. Also there is an embedded hexagonal hole to put a 3/8" nut in and thread a 3/8" bolt through if you want to mount it anywhere. That hole prints fine without supports, only the chin needs support.