Tineco A10/S12 Brush Wall mount

A simple and strong wall holder for the spare Tineco brush that holds the brush at one angle.

The model should be printed standing up (like the picture) with the help of a brim, no support is needed :)

Print settings (suggestions)

Print direction: Print the model standing up, so the print doesn't need any support, plus the direction will make the holder stronger. Use a brim to help adhesion as the part that touches the bed is relatively small.
Infill: 15% should be enough
Thickness: 4 perimeters
Layer height: 0.2mm on a 0.4mm nozzle should work well, but you can use a bigger layer height as tolerance are not super tight.
Support: None