Sans Amiibo Figure

Nice desing bro , can u make chara 😭

How did you give him seperate colors? it wasn’t different filiment was it? (edited)

Impreso en para mi hija de 12 años, que le encanta el personaje y lo quería pintar.

Impreso a 0.2 de capa y a una velocidad de 50mm/s.
ha quedado muy bien y el archivo no tenia fallos.

Modified the model sligthly and printed it with a 0.3mm layer height at a 20cm height but a few organic supports didnt stick well enough and the jaw failed :( (not shown in picture)

Came out great with 0.1mm layer height and tree supports. The pant legs were a little thin, so the bottom edges look frayed, though.