NSG Splatmaster Linkage Arm

My original linkage arm on my NSG splatmaster snapped in half so I decided to design up a replacement piece.

Print Settings

Rafts:

No

Supports: 

No

Resolution:

.12 MAXIMUM

Infill: 

20%

Filament: 

PLA is fine, PETG or Nylon recommended

Notes:

Print with 10 or more walls.

Post-Printing 

You will need 2 M2x4 bolts to reinforce the 2 barrel connector nubs.

Put the spring onto the linkage arm with the plastic detent ball in the barrel and connect the 2 together (might be a little tight depending on printer tolerances)

Category: Sport & Outdoors