Dyson Accessory Holder for IKEA Skådis

Unfortunately for me, I didn't find Dyson accessory holders for Skådis that make use of the phenomenal  T-Nuts for Ikea Skadis Pegboards system from 6d6178. So I had to do them myself.

The holders are mounted to the Skådis board with one T-nut (using a M2.5x12 screw). Additionally there are two passive alignment guides, so that the holder will not twist when the accessory is inserted or unhinged.

The three models differ in their distance to the wall.

Parameters for printing

The accessory holders can be printed without support or brim. The shown examples were printed with a layer height of 0.28mm and were oriented upside down.