Olympus OM D E-M10 Eyecup Replacement

This is a remix (combining of) 2 different STL Files. I did this using my very rudimentary knowledge of Tinkercad.

www.thingiverse.com/thing:2985864
and
www.thingiverse.com/thing:3417712

Two reasons for doing this  is the first stl had very sharp edges that when wearing camera on my neck would cause painon my chest if i was wearing a tee shirt. The second STL did not have way to attach without glue?  The second reason is that original Eyecup provided by Olympus for this camera is a little loose and very easy to lose (which I did) and replacements are very expensive

I printed with supports using PRUSA slicer and PLA. Did not try without supports or is any other filament type.

To install it, it drops down over the viewfinder. It is a tight fit so go slow until it seat all the way down.