Creality CR-10 Smart HeadLess front cover

That's a front cover replacement for headless CR-10 Smart due to motherboard replacement (no stock display). This is the full vented version that removes the stock tray too (i think it's useless).

It's part of a bigger set of mods i'm designing for CR-10 Smart (direct-drive - full-metal hotend - duet3d board bracket - contact-contact z-probe…).

BETA RELEASE - Only for testers. Print at your risk. Cannot guarantee that it will fit nicely on your printer. Had no time to test it adeguately. I'll eventually update it later.

If used with stock board, it needs a 4x4 M3 brass insert.

You'll need at least 400mm printer to print this! No support needed. PLA/PETG if CR-10 not enclosed. ABS/ASA mandatory for enclosed printers.

Enjoy!