Czech Koruna coin pocket holder

Description

Not much to talk about, it's a pocket coin holder/dispenser for Czech Koruna coins. It'll hold around 4 coins of each value, maybe 5 for the thinner coins.

 Dimensions:

• Length: 80.4mm
• Width: 53.7mm
• Height: 20mm

I also have a Euro version of this: https://www.printables.com/model/377634-euro-coin-pocket-holder

Additional, non-printed parts

This print requires 6 springs and 4 screws. The screws are M3 countersunk screws, the length can be either 16 or 18mm. Screws can't be larger than 18mm otherwise they'll stick out of the bottom and/or break the parts.

The springs are small compression springs, with a wide diameter of 0.6mm, outside diameter of 12mm, and length of 20 or 25mm.

These springs are a perfect match for this (select the sizes mentioned above): https://www.aliexpress.com/item/1005004196158892.html

Printing and post processing:

• No supports needed
• Recommend lightly sanding surfaces which will interface with one another (where the base joins with the top)
• If your print is prone to zits and blobs, sand these down too, otherwise the coins and discs will snag and not move properly
• Alternatively, the base and top can be glued together rather than screwed together. This will, however, prevent the coin discs and springs from being removed without breaking it