Wedge with Holes and Base (Customizable)

These are general purpose customizable wedges.  

When you open the file in OpenSCAD you can change:

• Dimensions:
  • The length and width of the wedge.
  • The angle of the wedge (Including 0 degrees for no wedge.)
  • The height of the base block. (Including 0 height for no base block.)
• Holes:
  • The number and diameter of the holes.
  • Whether the holes are perpendicular to the slope or perpendicular to the base.
  • The distance from the left edge to the first hole.
  • The distance between succeeding holes.
  • Whether the holes have counterbores at each end. 
  • The depth and diameter of the counterbores.
  • The counterbores can be round. Or they can be hex or square shaped to serve as nut traps.
• Print Orientation: 
  • You can choose the orientation of the output file: 
    • printing with the base down (resulting in a stairstep for each layer across the slope face)
    • or printing with the slope down (resulting in a smooth slope face).
• If you are new to using OpenSCAD Customizer, I have posted a brief guide.  http://bit.ly/openscad-at-home