Heim & Haus WGB Awning Holder

Purpose
This holder connects to to awning rail by German manufacturer Heim & Haus for their [WGB](https://www.heimhaus.de/markisen/wintergartenmarkisen/) (WinterGartenBeschattung = winter garden/sunroom shading). It works for the version without glas (above or below the shading), maybe also for a version with glas (but I have no access to one).

How to use
You can place it on top or below the rail, it does not interfere with the awning itself as it is placed similar to the posts or the (optional) wind sensor. *The lug has a diameter of 9mm.* You can use s-shaped hangers or a clipper, but don't put too much weight on it.
You will need *3x M3 x 45mm screws* (A2 quality for using outside, I took DIN 912) + *3x M3 nuts* (DIN 439 B).

Disclaimer:
I am not associated with Heim & Haus, just a customer searching for an easy solution.

Printing

• Print it on the L-shaped side for better sturdiness.
• No support needed.
• I used 0.2mm with 40 percent gyroid infill and printed with PLA.

ABS might be a better choice, but as my printer is not capable of it, PLA is the one.