Magnetic removeable scrap/filament/failed prints bin CR6SE

I made this for my CR6-SE so I could put all the skirts, purge lines and filament scraps in - so I don't have to go to a bin every time.

The base slides into the 2 slots in the 40mm x 40mm extrusion on the base of the printer.

10 holes (5 on top of base and 5 on bottom of bin) for 6mm x 3mm neodymium magnets (you could probably get away with only doing the corners so 8 magnets if you want to do that.)

I printed them so the bin was the flat the right way up and the base was on its side so that surface touching the build plate is like an L shape. Both of these will need supports - I oriented them so that using tree supports it would use the least filament. (used the new tree supports in cura 5.3 alpha… Think they're called organic tree support in prusa slicer?)  

Not sure if these will work with any other printers but if they have 40mm x 40mm extrusions on the frame then I would assume that they would if there's enough space for the bin (its 150mm long) - also bear in mind I modelled it to go lower than the extrusion as the CR6SE has those rubber feet, so if for whatever reason you don't have those rubber feet it won't work.