ONEPIECE Bookmark

Motivation

My son is a fan of One Piece, and having most of the published volumes, I decided to design a bookmark for him.

The design goals was to have a slim as possible leg that can be inserted in the book, and having the Straw Hat Pirates emblem out of the book.

Hope you will be able to print and enjoy this little bookmark as well.

Printing the model

The model is very simple, it is composed by a single (one piece) printed part.

The emblem was imported from a vector image format (SVG) into Fusion360, and from there all the magic was added.

It has 5 groups of layers, each group is to be printed in a different color, to do so, you need to instruct your Slicer software (I use Prusa Slicer) to do a color change on the corresponding layer.

• The first group of layers to be printed in Gray (For the background, can also be Black)
• The second group of layers to be printed in White (For the bones of the emblem)
• The third group to be printed in Black (For marking the borders)
• The fourth group to be printed in Yellow (For the Straw Hat)
• The fifth (last) group to be printed in Red. (For the hat band)

If you print with a layer height of 0.2 mm, then the color changes are at layers 4,7,10,13 which correspond to the heights of 0.8mm, 1.4mm, 2.0mm and 2.6mm respectively.

For the color change, I followed the instructions in “Color Change” page of the PrusaSlicer documentation.

I printed the model using my Prusa MINI+ Printer using the following parameters:

Last Words

• I hope you like this model and if you like it, please give it a like, it will make my day and will allow me to get a Prusa mug.
• Don't hesitate to post your makes including comments that can improve the model.
• You are kindly invited to follow me to get updated every time I upload a new model.

And the most important: Happy printing & Greetings from the Galilee.

Hope it was not TL;DR