logitech g29 F1 wheel

Easy to print F1 style wheel. Goes together with glue/epoxy, or if you want the ability to change handles you can use Qty 4 M3x14 screws, Qty 4 M3 nuts, and Qty 8 M3 washers. This design was tested on a G29, but likely fits on G27/G920. Please search for instructions on removing the stock wheel, then this wheel simply attaches using the 6x center screws. I have included two button plungers to reach down and touch the stock switches. You will need 2x of each plunger length.

Recommend printing with at least 35% infill for acceptable stiffness. Only use support material in the screw holes on the front face. Assemble the two-piece handles with super glue or epoxy. Do not over-tighten the 6x G29 hub screws.