Uplift Sculpture Printable Non Glass Replacement Glass Dome

A printable stand to hold the magnet up in place of the glass dome used in the uplift sculpture.

Here is a link for those who dont know what Im talking about

I printed all pieces on a prusa mini, PLA, 0.6mm nozzle, 0.3mm layer hight, and 15% gyroid infill.

Printed parts needed:

• 1 x Base Ring
• 9 x Base Post
• 3 x Mid Ring
• 1  x Top Ring
• 3 x Top Post
• 1 x MagCap

You're going to want to use super glue to glue the pieces together and use binder clips as clamps to keep everything together as you assemble.

Put together from the base up, giving at least 3 minutes for the superglue to fully structurally cure before moving on to the next level.