CR-6 SE Filament Sensor Mount

 Original mount requires pnuematic or 4mm Push-fit Collet and have some fitting issues. 

 This mixed runout sensor mount for the CR-6 SE is designed to correctly line up to a bowden installed Direct Drive system. 

 The mount has  pneumatic fitting for side mounted filament spools. The output is designed so that a carefully cut length of PTFE tube can run between the sensor and the extruder.

Layer Height : 0,20
Infill : %15
Raft/Brim : No
Support : Support from Build Plate

Notes: for pneumatic side; little support required. Also you may print at low speed and use lower layer height to increase quality.