Nozzle Wrench

Simple Nozzle Wrench for easy installation and removal of nozzles!  It makes swapping out nozzles super easy and convenient!

I don't recommend using it on a hot nozzle because most plastics will melt.  Loosen the nozzle with a metal wrench, wait for the nozzle to cool, and then remove it.  When putting in a new nozzle, put it on cold, heat it, and tighten it with a metal wrench.  I also use it to put nozzles in the nozzle card that I have on my page as well.

A metal nozzle wrench that's the same design as this is still better, in my opinion, but they can be hard to find to buy, and this solution is practically free.

This wrench is just convenient cause it holds the nozzles well and makes removal and installation super easy. 

Printed in Inland PLA. The total print time is about 30 minutes.  There is also enough clearance to fit over a dirty nozzle, it is just a little tighter, obviously. 

Please leave comments and makes so I can make any necessary improvements!