E61 Shaker Redistribution Dosing Cup for ECM 64 Grinder

There are two requirements I wanted to solve with the remix: 

1. Get rid of the uneven coffee distribution in E61 coffee compartments, which was the original use of the shaker cup, like described in the original print project.
2. Grind for a multiple of regular espresso coffee shots for use in a normal filter machine or manual filtering. Obviously, a whole can of coffee needs some more coffee to be grinded… In parallel, get rid of the extra funnel I normally use for grinding with my ECM 64 grinder. So the height of the shaker cup had to be optimized to fit.

I had my difficulties in getting round edges on the baseplate of the shaker cup after cutting off the lower part of the original shaker cup. In the end, I had to create an extra Fusion360 body to successfully round the edges. This is not a groundbreaking work of remix. Nevertheless, I attached the Fusion360 sources.

Nothing special for the print settings. PET-G, 0.2mm layer height, no supports.

Have lots of good coffee!