The Panzer : Bondtech BMG + V6 / Volcano / MK8 / Microswiss print head for Creality CR-10 and Ender3 (a remix of "The Tank")

Thanks to the original creators Greg191134 and techoutreach for their work.

This model and is based on techoutreach's version with a few tweaks. Like techoutreach's version, you can change the hotend without removing the BMG extruder.

• There's a new Fan Shroud with better visibility on the nozzle (Thanks to Günter Michaeller for his idea)
• You can mount a 8mm Endoscope using the new fan shroud 8mm endoscope on AliExpress
• V6 Volcano is supported (the blower fan and the shroud can be lowered and there's a spacer for the BLTouch)
• There's a MK8 Version (Not tested but should work) and an "adapter" too to convert the V6 mount to allow mounting temporarily an MK8
• You can choose with or without Heat Inserts
  • M3 x 3mm x 4mm : YUBABA Store on AliExpress
  • M3 x 12mm x 4mm : YUBABA Store on AliExpress

Everything is designed with OnShape, feel free to modify it !

Marlin configuration

#define NOZZLE_TO_PROBE_OFFSET { 32, -2, 0 }

Printing

The design is quite forgiving, especially using heat inserts, I printed it with good results in ABS, using a 0.6mm nozzle, 0.35mm layer heights, 4 perimeters (0.65 line width => 2.6mm shell), a 10mm brim and a bit of hairspray.

I included a .3mf project file of the last print settings I used, your milage may vary.

You can open it using SuperSlicer: https://github.com/supermerill/SuperSlicer

Changelog:

V7: Added an optional 8mm endoscope holder to the new fan shroud.

V6: Trimmed a bit the new fan shroud to make it more suitable for MK8 heater block.

V5: Initial release

Bill of materials:

Screws

• 3 x Hex screw M3x0.50 x 8
• 4 x Hex screw M3x0.50 x 35
• 1 x Hex screw M3x0.50 x 22
• 2 x Hex screw M3x0.50 x 20
• 5 x Hex screw M3x0.50 x 16
• 2 x Plain washer M4

See here if you need screws:

• YUBABA Store on AliExpress
• OG House Improvement Store on AliExpress

With Heat Inserts

• 1 x M3 x 12mm x 4mm
• 9 x M3 x 3mm x 4mm