Box for Smart Home Bridges

Motivation

All smart home bridges in one place was the goal of this project. At the same time, as little cable clutter as possible.

There are 2 versions for the floor. Depending on the mounting on the wall choose one of these versions
- Tado horizontal -> no matter
- Tado vertical -> choose the variant where the stopper points to the floor

As orientation, on my pictures you can see that I printed the wrong one ;)
Well, at least it was the only version at the time ^^

Hint:
Put the cables on the Bosch BEFORE clicking it on the Plate. It hard to get it off again without breaking the snap-in-pin. Use something flat to push back the pin before lifting the Bosch SHC.

Warning:
The current version fits on the Bambulab X1 Buildplate but NOT on my Prusa MK3S. Cut and glue or let me know if I should try to optimize the size. At the moment I don't know if this project is interesting for a few more people.

Housing for

Philips Hue
Tado
Bosch Smart Home Controller

How to print

Nozzle: 0.4mm
Height: 0.2mm
Supports: helpful but not necessary
 

What you need

Some M3 Screws and Nuts

For the Hue mount I got inspired by this
https://www.printables.com/model/125408-philips-hue-bridge-rack-mount