Landscape Light Stake

24mm landscape light stake. Originally designed for Hamilton Beach solar landscape lights. Will fit or can be rescaled for others. If you have the wired ones, you will want to cut a slot in the stop ring (the only horizontal surface) to accommodate the wire.  I did not include it for the solar folks because it would complicate the print slightly and I wanted this to be efficient. 

Print Info:

PLA, its is underground. Mine has been working fine for a year with no signs of fatigue. PETG, ASA, ABS for those who are ambitious. 

I used a 0.06 nozzle at 0.36 layer height at 70mm/s

5 walls, essentially 100% infill

1.5 hour print 

Brim

No supports needed. I did use “Experimental → Make Overhang Printable” and set “Maximum Model Angle” to 65 to make the stop ring for the light print easier. If you have your machine dialed in or have your bridge setting set up you will not need to do anything.  

GCODE print and go file include if you are running a 0.06 Nozzle, PLA (may need to change temp)