BambuLab AMS Dryer pod without moisture meter my own new revision

143

1803

12 k

updated January 22, 2023

Very nice thanks

filled up three of these with desiccant and went from reading a "3" on the AMS to a "1" in less than 30 minutes - great work!

👍

I used tree support, was a breeze to remove. Not sure if it was needed but had it there to err on the safe side. Print was easy, installation was easy. AMS is happier for it. Cheers Joergel for the design and opensource! :)

J 13

Just_a_Printer

@Just_a_Print_1355443

No supports needed

J 2

jonsey

@jonsey_1249656

If i can suggest the printing position, leave it stand up...the supports in other position are sooo difficult to remove!
Thanks for the files! :)

jomiller97

@jomiller97_1165286

what silica did you use to fill this? Link would be great

K 16

Klave

@Klave

@jomiller97_1165286 : I bought "indicating dessicant" from Amazon. You can choose blue that goes red or yellow that goes green. The beads are quite big and won't fall out. Both types can be "recharged" when they are full of moisture by slowly heating to a low temperature in the oven. Supposedly, too fast and they crack when the moisture exits the beads, too hot and the colour changing material gets damaged and you loose the indicating feature (edited)