MAK Spool Winder / Stand

Heavy duty, universal spool stand / winder for filament spools. Robust design, simple assembly, reliable operations.

The spool is protected from pulling it up during rewinding with lock bars, which are hold in place by lock pins. Additionally lock bar pins can be secured in place with a piece of filament (please see pictures; piece of filament should be glued into the locking pin).

Supported spool sizes:

• up to 210 mm outer diameter
• 39-60 mm inner spool hub diameter
• 38-78 mm wide

Various spool hubs are provided, marked 45-50-55-60 mm which indicates inside spool diameter. Every hub can support designated size minus 7 mm (i.e. a hub marked 55 mm will fit spools with internal diameter of 48-55 mm). You may contact me in the comments if other size would be needed.

Dedicated spool hub is provided for Bambu Lab spools, to fit them perfectly.

Crank is optional and should be assembled using crank pin and mounted to the axle with crank bolt. Both crank pin and bolt will fit tightly, so in most cases no glue is needed.