Thermistor Antenna

BOM: 

• SHCM3x30mm [1x]
• M3 Voron heat-set insert [1x]

Compatibility:

• Voron ClockWork2 Extruder;
• CW2 style mounts for other extruders, as long as they feature the mounting hole previosuly used to engage the latch.

Warning: the ring notch on the piece assumes you pushed the heat-set insert below the surface, as the manual says.

Instructions:

1. Press the heat-set insert into the printed part;
2. Cut the connector (if present) off the thermistor;
3. Insert the bare wires throught the hole;
4. Lightly pull it out;
5. Insert the thermistor into the mount. Do not apply too much pressure, twist it in.