Coffee funnel for 57mm porta filter

This is a funnel similar to the aluminum ones, for a 57mm portafilter (Lelit and Ascaso espresso machines mainly use them).

The sizes are optimised for a 0.6 nozzle but should print fine using 0.4. if you want a 0.4 optimised one ask me for it and I will upload it.

The 3 holes are for 3mmx1mm magnets. You can glue them in there so it snaps into place and you don't have to hold it on the portafilter.

Print Settings

Printer:

Voron 1.8

Rafts: 

No

Supports:

No

Resolution: 

0.1

Infill:

15%

Filament:

PETG preferably as PLA might melt if you leave it on a hot portafilter for a long time 

Fire engine red

Category: Kitchen & Dining