Xtool Dual Module Holder (10w/20w)

Was tired of just laying my unused modules around.  These expensive devices deserve better treatment!!  Introducing a dual module holder that fits both a 10w and 20w!

WARNING
 - NOT compatible if you use the orange laser shield!
 - ONLY tested with my 20w air assist (https://www.printables.com/model/376375-jc-xtool-d1-20w-air-assist) and Cobey's original 10w air assist.  As long as clearances are similar others will fit, but print at your own risk.

PLA, .4 nozzle, .3mm layers, no supports.  Nozzle and layers could be thicker without issue.