The kit is inspired by alpo16000 this variant also works from both sides but you would have to change the wiring of the sensor to be able to load from the left side. Therefore, I have thought to put the unit in the middle and to lead the PTFE hose.
UPDTAE:
This is a drastically reworked version, in the first attempt the sensor holder was not movable and caused too much friction.
Now the sensor holder can move on the M3 screw. The self-locking nut must be inserted in the fraem clip so that the sensor holder can not loosen.
Material:
-PTFE hose (4mm outer diameter)
-M3 self locking nut
-M3 X 8mm screw
-Nutstone M5 (2X)
-M5 X 10mm screw (2X)
-Pneumatic connection M6 thread
-M3 nutz (2X)
No support is needed, PLA can be used as material. Standard layer heights can be used without any problems.
If you have any questions please contact us
The author remixed this model.