IStick Pico Honeycomb Case

So basically I wanted to have a protective case for this awesome little vape but those that I have found didn't really work for me because the lack of grip that I want, so I designed this case in Fusion 360 for like 3 days :/ but it came out awesome and I wanted to share it with my fellow Pico users.

You will probably need to sand the insides just a bit to smoothen it up cause this is a nice firm fit.

For the case I recomend 3 perimeters because I had some problems on 2 perimeters (the printer would print infill like 3mm lines and then do the perimeter and it fails eventually resulting in a nasty print).

I printed the case without any supports at 0.16 layer height and 15% infill cause it needs to look dope, the fire button and the adapter ring I printed at 0.08 and 45% infill just because I wanted them to look as slick as possible.

I added this "adapter ring" as I use a Berserker MTL RTA and I had to buy that cooling thingy to be used as an adapter and it looked plain stupid so 3 mins of Fusion 360 and voila, much better. BTW it needs to be rotated 180 degrees.

Print Settings

Printer:

Anet A8

Rafts:

Supports:

No

Resolution:

Infill:

15% to 45%